CNET CWR-854 Guía de instalación

CWR-854Wireless-G RouterQuick Installation Guide

9PPTP: Thisconnection type isavailable in Europe.Select this option ifyou are connectingthrough PPTP. Enterthe information asprovided by yourISP.9. Co

10Mode: The default setting of AP (Access Point) allows this wirelessrouter to bridge the wired and wireless networks. Select Client to usethi

11longer than 100 meters. Make sure the IP addresses of your computer and the wireless routerare in the same range. Set your computer to receive an I

1RequirementsThe following components are needed to setup the wireless router: A computer with a wired or a wireless network card Broadband Internet

2Setting Up Your ComputerThis section shows you how to configure your computer to obtain an IPaddress from the wireless router. This ensures that your

34. In the screen that displays, selectObtain an IP addressautomatically.5. Click Advanced and remove allgateway information and clickOK.6. Click OK t

4Configuring the Wireless RouterThese steps show you how to configure the wireless router using the SetupWizard.1. Make sure the computer is connected

55. In the first wizardscreen, select theoperation mode toallow the wirelessrouter to configurethe WAN interface tobe wire (Gateway orBridge) or wirel

67. You can change theLAN interfacesettings in thesecond wizardscreen. ClickNext>>.8. The third wizardscreen variesdepending on thetype of Inter

7Static IP: Select thisoption if your ISP givesyou a fixed WAN IPaddress. Complete thisscreen with theinformation provided byyour ISP.

8PPPoE: Select thisoption if you areconnecting throughPPPoE. Enter theInternet accessaccount user nameand password.